GSC100 Series AutoStart Engine Controllers

The lowest cost AutoStart solution on the market is sophisticated enough to handle all types of generators. Specialized for small generator applications such as portables, residential, and light commercial. Standard features include: Underspeed; Not-in-Auto Indication; Battery Voltage Sensing, plus Generator AC Speed Sensing.

Request more information

Fixed Controller Settings
- Crank Disconnect - Overspeed - Crank Tries - Crank/Rest
Zero Speed Restart - If the speed of the controller does not go to zero during Crank/Rest the controller will wait until the speed goes to zero before re-initiation the cranking sequence.
General Fault Conditions
- Low Oil - High Coolant Temperature - Overcrank - Overspeed - Underspeed
Underspeed
If the speed of the controller falls below a fixed set point for a fixed time period the controller will shut down the engine and prevent re-starting while energizing the Underspeed LED.
Not In Auto
When no power is applied to the AUTO terminal and +12VDC is maintained to the NOT IN AUTO terminal, the NOT IN AUTO LED will illuminate indicating the AUTO/OFF/TEST is not in the AUTO position.
Low Battery Voltage
If the battery voltage drops below a fixed setting the Low Battery condition is displayed.
Low Oil Input
Can close to +V Battery or to Ground to initiate a failure and is disabled during Oil Bypass.
High Temperature Input
Can close to +V Battery or to Ground to initiate a failure.
Speed Signal Sensitivity
Accepts up to 300VAC, 60Hz from Direct Generator Output for speed sensing.
Time Delay on Engine Start (TDES)
Provides a delay before the engine is started where an output is energized between the time the start/stop signal is provided to the controller and cranking is begun. (LED flashing)
Optional Fixed Cool-Down Period
Will keep the engine running for a fixed period after the start/stop signal is removed. With wire jumper cut Cool-Down is disabled and the unit will shut off engine when start/stop signal is removed.